Device Support Summary For "Cypress S25FL512SDSMFA013" |
|
|
Generated by: | BPWin V8.0.1 DeviceSupportUpdate.29 (3/27/2024) |
|
|
Device Parameters |
|
Manufacturer: | Cypress (ID=1h) | Part Number: | S25FL512SDSMFA013 (ID=19h) | 8-bit Bytes: | 67109896 | Memory Regions: | 0h-3FF FFFFh; 400 0010h-400 03FFh; 400 0400h-400 0407h | Vcc(program): | 3.6 | Electrical Erase: | Yes | Set programming: | Yes | Packages: | SOIC(16) |
|
|
Note |
|
IMPORTANT:
Device Type: | SPI Flash Memory |
Device Size: | 512M-bit |
Algorithm Programming Method: | SPI |
Memory Organization:
Memory Type |
Attributes(*) |
Included in default Range (Y/N) |
DUT Physical Byte Address(hex) (if this area is selected/Activated) |
BPWin Buffer Byte Address(hex) |
Main Flash Area |
R/W/E |
Yes |
0000_0000 - 03FF_FFFF |
0000_0000 - 03FF_FFFF |
OTP |
R/W |
No |
0400_0010 - 0400_03FF |
0400_0010 - 0400_03FF |
Password |
R/W |
No |
0400_0400 - 0400_0407 |
0400_0400 - 0400_0407 |
Default Algorithm Range |
--- |
--- |
0000_0000 - 03FF_FFFF |
0000_0000 - 03FF_FFFF |
* R/W: readable and one time programmable (OTP), R/W/E: readable and rewritable if not locked.
Any configurations listed under "Device-Specific" in the menu item Device->Settings
will be written to the DUT during "Program" operation, regardless of memory range selection.
Special Device Considerations:
1. | Serialization Supported: | Yes |
2. | The Factory Programmed 128-bit random number located at the beginning of the OTP region
cannot be programmed. The data in this number will not be shown in the Buffer Editor. |
3. | OTP Lock bits are located in Buffer Addresses [0400_0010h - 0400_0013h]. If any of these bits
are programmed, this algorithm will not be able to program additional bits in the OTP region. |
4. | OTP Reserved bits are located in Buffer Addresses [0400_0014h - 0400_001Fh]. |
5. | The correct password value, located in Buffer Addresses [0400_0400h - 0400_0407h], may only be read
before the Password Protection Mode in the ASP Register (ASP[2]) bit has been programmed to '0'. |
5. | The Persistent Protection Bits (PPB) may be programmed under Device->Settings.
Each Group is divided into 256K-Byte blocks of data. This is condensed version of PPBAR for each sector. |
|
|
|
= Supported |
|
|
† = This is a replacement daughter card that requires a base socket module |
|
|
Automated Production Programmers |
|
|
|
Manual Production Programmers |
|
|
|
Copyright © 2024, BPM Microsystems |
|
|