Device Support Summary For "Cypress S25FL512SAGBHIC13"

 
Generated by:BPWin V8.0.1 DeviceSupportUpdate.29 (3/27/2024)
 
Device Parameters

Manufacturer:Cypress (ID=1h)
Part Number:S25FL512SAGBHIC13 (ID=19h)
8-bit Bytes:67109896
Memory Regions:0h-3FF FFFFh; 400 0010h-400 03FFh; 400 0400h-400 0407h
Vcc(program):3.6
Electrical Erase:Yes
Set programming:Yes
Packages:BGA(24)
 
Note

IMPORTANT:
Device Type: Flash Memory
Device Size: 512 Mbit
Algorithm Programming method: SPI

Memory Organization:
Memory Type

Attributes(*)

Included in default
Range (Y/N)
DUT Physical Byte Address(hex)
(if this area is selected/Activated)
BPWin Buffer Byte Address(hex)
Main Flash Area R/W/E Yes 00000000 - 03FFFFFF 00000000 - 03FFFFFF
OTP R/W/E N0 04000010 - 040003FF 04000010 - 040003FF
Password R/W/E N0 04000400 - 04000407 04000400 - 04000407
Default Algorithm Range --- --- 00000000 - 03FFFFFF 00000000 - 03FFFFFF
* R:Read only, W:One time programmable (OTP), R/W:readable and one time programmable (OTP), R/W/E:readable and rewritable if not locked. Any configurations listed under "Device-Specific" in the menu item Device-> Settings will be written to the DUT during "Program" operation regardless of memory range selection. 512M-bit Serial Flash. This algorithm uses Standard SPI mode to Program and Verify/Read the device. The status register bits can be set under Device Config > Configure . Erase must be selected if device to be programmed already has QE bit enabled. The default Device Range is set to [0000000h-3FFFFFFh]. Please modify the range under Device Config > Range if any of the Security Registers need to be included. The correct password value, located in the range [4000400h-4000407h], may be read only after it is programmed and before the Password Mode has been selected by programming the Password Protection Mode bit to 0 in the ASP Register (ASP[2]). The OTP region is located in the range [4000000h-40003FFh]. The Factory Programmed 128-bit random number located at the beginning of the OTP region cannot be programmed, and data in this region will not be shown in the Buffer Editor. OTP Lock bits are located in the Buffer location [4000010h-4000013h] and Reserved bits are located at [4000014h-400001Fh]. The device lock bits may be programmed under Device Congig > Configure. Each Group is devided into 256K Bytes of data.
 
= Supported
 
= This is a replacement daughter card that requires a base socket module
 Automated Production Programmers
Programmer Model:39004900380048003000FS-MK23000FS
Algorithm Code Revision:1.11.11.11.11.11.1
 
BGA Socket Modules (Sorted by Performance)
FVE4ASMC24BGJ
FVE4ASMC24BGT
FVE4ASM24BGB
 Manual Production Programmers
Programmer Model:1900290028002800F-MK22800F
Algorithm Code Revision:1.11.11.11.11.1
 
BGA Socket Modules (Sorted by Performance)
FVE4ASMC24BGJ
FVE4ASMC24BGT
FVE4ASM24BGB
 
Copyright © 2024, BPM Microsystems
 
Last Updated: 01/14/2021