Device Support Summary For "Cypress S99FL512SDSMFBG11" |
|
|
Generated by: | BPWin V8.0.1 DeviceSupportUpdate.29 (3/27/2024) |
|
|
Device Parameters |
|
Manufacturer: | Cypress (ID=1h) | Part Number: | S99FL512SDSMFBG11 (ID=19h) | 8-bit Bytes: | 67109896 | Memory Regions: | 0h-3FF FFFFh; 400 0010h-400 03FFh; 400 0400h-400 0407h | Vcc(program): | 3.6 | Electrical Erase: | Yes | Set programming: | Yes | Packages: | SOIC(16) |
|
|
Note |
|
IMPORTANT:
512M-bit Serial Flash.
This algorithm uses Standard SPI mode to Program and Verify/Read the device.
The status register bits can be set under Device Config > Configure .
Erase must be selected if device to be programmed already has QE bit enabled.
The default Device Range is set to [0000000h-3FFFFFFh].
Please modify the range under Device Config > Range if any of the Security Registers
need to be included.
The correct password value, located in the range [4000400h-4000407h], may be read only after it is programmed
and before the Password Mode has been selected by programming the Password Protection Mode bit to 0 in the
ASP Register (ASP[2]).
The OTP region is located in the range [4000000h-40003FFh].
The Factory Programmed 128-bit random number located at the beginning of the OTP region cannot be
programmed, and data in this region will not be shown in the Buffer Editor. OTP Lock bits are located
in the Buffer location [4000010h-4000013h] and Reserved bits are located at [4000014h-400001Fh].
The device lock bits may be programmed under Device Congig > Configure. Each Group is devided into
256K Bytes of data |
|
|
= Supported |
|
|
† = This is a replacement daughter card that requires a base socket module |
|
|
Automated Production Programmers |
|
|
|
Manual Production Programmers |
|
|
|
Copyright © 2024, BPM Microsystems |
|
|