Device Support Summary For "Cypress S70FS01GSDSBHV21" |
|
|
Generated by: | BPWin V8.0.1 DeviceSupportUpdate.29 (3/27/2024) |
|
|
Device Parameters |
|
Manufacturer: | Cypress (ID=102h) | Part Number: | S70FS01GSDSBHV21 (ID=214Dh) | 8-bit Bytes: | 134218752 | Memory Regions: | 0h-3 FFFFh; 4 0000h-3FB FFFFh; 3FC 0000h-3FF FFFFh; 400 0000h-403 FFFFh; 404 0000h-7FB FFFFh; 7FC 0000h-7FF FFFFh; 800 0010h-800 03FFh | Vcc(program): | 1.9 | Electrical Erase: | Yes | Set programming: | Yes | Packages: | BGA(24) |
|
|
Note |
|
IMPORTANT:
1 Gigabit MirrorBit Flash memory.
Dual Die Stack of two FS512S die.
This algorithm uses Standard SPI mode to Program and Verify/Read the device.
The status register bits can be set under Device Config > Configure .
The default Device Range is set to [0000000h-7FFFFFFh].
Please modify the range under Device Config > Range if any of the Security Registers
need to be included.
The OTP region is located in the range [8000000h-80003FFh].
The Factory Programmed 128-bit random number located at the beginning of the OTP region cannot be
programmed, and data in this region will not be shown in the Buffer Editor. OTP Lock bits are located
in the Buffer location [8000010h-8000013h] and Reserved bits are located at [8000014h-800001Fh]. |
|
|
= Supported |
|
|
† = This is a replacement daughter card that requires a base socket module |
|
|
Automated Production Programmers |
|
|
|
Manual Production Programmers |
|
|
|
Copyright © 2024, BPM Microsystems |
|
|