Device Support Summary For "Infineon(Siemens) SAK-XC161CJ-16FF (ISP) (with adapter) TPA"

 
Generated by:BPWin V8.0.1 DeviceSupportUpdate.29 (3/27/2024)
 
Device Parameters

Manufacturer:Infineon(Siemens) (ID=41h)
Part Number:SAK-XC161CJ-16FF (ISP) (with adapter) TPA (ID=96h)
16-bit words:65536
Vcc(program):2.5
Electrical Erase:Yes
Secure:Yes
Set programming:Yes
Packages:DIP(28) QFP(144)
 
Note

IMPORTANT: This device requires the use of a third party adapter. This is an ISP solution to be used with a WirePro test fixture. This algorithm is valid for devices starting with and including design step AC. Single-Chip Microcontroller with 128KByte Flash Memory. The 128KByte Flash Memory is mapped to Buffer addresses [00000h-1FFFFh]. Make sure that the default buffer value under "Buffer/Options" is set to 00h before loading data patterns. The read, write protection and passwords are described under Device/Configure. It is programmed with the Device/Secure command. To program the Device/Configure options, you must select the appropriate options in that menu, and set "Secure after programming" to 'ENABLE' in the Device/Options menu. Otherwise none of the options will be programmed with the Program command. If a device was previously programmed with a set of passwords with read protection enabled, the device can NOT be accessed any more. If a device was previously programmed with a set of passwords with only write protection enabled, a stand alone Erase operation must be executed first with correct passwords before attempting to reprogram it with a new set of passwords.
 
= Supported
 
= This is a replacement daughter card that requires a base socket module
 
Copyright © 2024, BPM Microsystems
 

Last Updated: 01/14/2021