Device Support Summary For "Infineon(Siemens) SAK-XC164CS-16FF" |
|
|
Generated by: | BPWin V8.0.1 DeviceSupportUpdate.20 (3/12/2024) |
|
|
Device Parameters |
|
Manufacturer: | Infineon(Siemens) (ID=41h) | Part Number: | SAK-XC164CS-16FF (ID=96h) | 16-bit words: | 65536 | Vcc(program): | 2.5 | Electrical Erase: | Yes | Secure: | Yes | Set programming: | Yes | Packages: | QFP(100) |
|
|
Note |
|
IMPORTANT: This algorithm is valid for devices starting with and including design step AC.
Single-Chip Microcontroller with 128KByte Flash Memory.
The 128KByte Flash Memory is mapped to Buffer addresses [00000h-1FFFFh].
Make sure that the default buffer value is set to 00h before loading data patterns.
The read, write protection and passwords are described under Device Configure.
It is programmed with the Secure command.
To program the Device Configure options, you must select the appropriate options in that menu, and
set "Secure after programming" to 'ENABLE'.
Otherwise none of the options will be programmed with the Program command.
If a device was previously programmed with a set of passwords
with read protection enabled, the device can NOT be accessed any more.
If a device was previously programmed with a set of passwords
with only write protection enabled,
a stand alone Erase operation must be executed first with correct passwords
before attempting to reprogram it with a new set of passwords. |
|
|
= Supported |
|
|
† = This is a replacement daughter card that requires a base socket module |
|
|
Automated Production Programmers |
|
|
|
Manual Production Programmers |
|
|
|
Engineering Programmers |
|
|
|
Copyright © 2024, BPM Microsystems |
|
|